From the tablet to the machine

Fast and efficient: Biegemaster software allows you to draw the required folded profiles on your tablet on the construction site and later transfer it directly onto your bending machine via Bluetooth.

Available for: All BMS multi-touch control systems

Automatic gripper system

The automatic controlled grippers fix and position the sheet metal during profile creation. This reduces the manual intervention in the bending process to a minimum.

Available for: XBend

Conical back gauge

Enables the production of folded parts with widely varying depths (individual, conical bending) as well as profiles with a narrow and wide profile side (interlock function). In order to be able to suitably make the conical sheet cuts, a laser line at the sheet metal placement area indicates the millimetre-precise position.

Available for: XBend and BendTron

Insertion depth of 1250 mm

For cuts such as trapezoidal sheets, all our machines can be supplied with an insertion depth of up to 1250 mm.

Available for: All models

Automatic clamping beam adjustment

The hydraulic clamping beam adjustment (air gap adjustment) enables the adaptation to different sheet thicknesses.

Available for: All models

Non-abrasive placement area

Polyethylene or brush table placement areas enable the scratch-free and non-abrasive processing of sensitive, lacquered or delicate materials.

Available for: XBend und BendTron

BMS multi-touch control system

With data exchange option

The BMS multi-touch control system enables intuitive operation by touching the screen. This ensures that new profiles can be created quickly or created using touchscreen painting. The control system can draw on stored profiles. Automatic bend sequence calculations with graphic simulation and illustration complete this all-rounder.
For a highly efficient work preparation, the simple profile creation is also possible in advance with our software at the office workplace and can subsequently be transferred to the machine.
With the BMS multi-touch control system, even untrained users can create profiles themselves in a short amount of time. Biegemaster can provide support to users of the BMS multi-touch system when creating profiles or reading out parameters for a subsequent analysis via a remote maintenance function.
Electronic back gauge included.

Available for: All models

BMS 150 / BMS 100 control system

With electronic back gauge TAZ 1000 (only BMS 150)

With the programmable SPS control system BMS 150 can store up to 100 profiles with up to 10 angles each and the respective back gauge position. The table overview is displayed on a 10-inch touchscreen.
The back gauge is driven electronically by a timing belt and is equipped with multiple back gauge fingers. The back gauge fingers are continuously adjustable over the entire machine length.

BMS 100
Like BMS 150, however without back gauge.

Available for: Dura

BMS 10

The programmable control system BMS 10 enables up to 10 bending angles to be programmed for the profile. Table overview in a 7-inch screen.

Back gauge: Optionally with manual back gauge

Available for: Dura

Standard control system

The classic functional control system for simple profiles and occasional bending. The bending angle is pre-set via the rotation indicator. After bending, the clamping beam opens automatically. Opening heights are continuously adjustable.

Back gauge: Optionally with manual back gauge

Available for: Dura